HPE7-A01 Dumps Questions Increase Your Chance of Success

1. You need to configure an ACL on an Aruba switch to block HTTP traffic but allow HTTPS.

Which of the following ACL rules accomplishes this?

2. Which Aruba AP mode is sending captured RF data to Aruba Central for waterfall plot?

3. Due to a shipping error, five (5) Aruba AP-515S and one (1) Aruba CX 6300 were sent directly to your new branch office You have configured a new group persona for the new branch office devices in Central, but you do not know their MAC addresses or serial numbers The office manager is instructed via text message on their smartphone to onboard all the new hardware into Aruba Central.

What application must the office manager use on their phone to complete this task?

4. Using Aruba best practices what should be enabled for visitor networks where encryption is needed but authentication is not required?

5. A customer has a site with 200 AP-515 access points 75AP-565 access points installed. The customer is rolling out new mobile phones with Wi-Fi-calling. 802.1X is in use for authentication.

What should be enabled to ensure the best roaming experience?

6. List the firewall role derivation flow in the correct order

7. You are deploying a bonded 40 MHz wide channel.

What is the difference in the noise floor perceived by a client using this bonded channel as compared to an unbonded 20MHz wide channel?

8. You are setting up a customer's 15 headless loT devices that do not support 802.1X..

What should you use?

9. Your customer is having connectivity issues with a newly-deployed Microbranch group The access points in this group are online in Aruba Central, but no VPN tunnels are forming..

What is the most likely cause of this issue?

10. What is one advantage of using OCSP vs CRLs for certificate validation?

11. What are the requirements to ensure that WMM is working effectively'? (Select two)

12. What is a primary benefit of BSS coloring?

13. Your manufacturing client is having installers deploy seventy headless scanners and fifty IP cameras in their warehouse These new devices do not support 802.1X authentication.

How can HPE Aruba reduce the IT administration overhead associated with this deployment while maintaining a secure environment using MPSK?

A. Have the installers generate keys with ClearPass Self Service Registration.

B. Have the MPSK gateway derive the unique pre-shared keys based on the MAC OUI.

C. Use MPSK Local to automatically provide unique pre-shared keys for devices.

D. MPSK Local will allow the cameras to share a key and the scanners to share a different key

14. Your customer has an Aruba CX 6200F VSF stack with two switches. A third member (JL726A) needs to be added to the VSF configuration.

What e the configuration that enables the new devices to join the VSF?

A)





B)





C)





D)

15. What steps are part of the Key Management workflow when a wireless device is roaming

from AP1 to AP2? (Select two.)

16. What is the best practice for handling voice traffic with dynamic segmentation on AOS-CX switches?

17. Which method is used to onboard a new UXI in an existing environment with 802.1X authentication? (The sensor has no cellular connection)

18. You are configuring Policy Based Routing (PBR) for a subnet that will be used to test a new default route for your network Traffic originating from 10.2.250.0/24 should use a new default route to 10.1.1.253. Other non-default routes for this subnet should not be affected by this change.

What are two parts of the solution for these requirements? (Select two.)

A)





B)





C)





D)





E)

19. A customer is using a legacy application that communicates at layer-2. The customer would like to keep this application working to a remote site connected via layer-3 All legacy devices are connected to a dedicated Aruba CX 6200 switch at each site.

What technology on the Aruba CX 6200 could be used to meet this requirement?

20. In AOS 10. which session-based ACL below will only allow ping from any wired station to wireless clients but will not allow ping from wireless clients to wired stations"? The wired host ingress traffic arrives on a trusted port.

A. ip access-list session pingFromWired any user any permit

B. ip access-list session pingFromWired user any svc-icmp deny any any svc-icmp permit

C. ip access-list session pingFromWired any any svc-icmp permit user any svc-icmp deny

D. ip access-list session pingFromWired any any svc-icmp deny any user svc-icmp permit

21. When setting up an Aruba CX VSX pair, which information does the Inter-Switch Link Protocol configuration use in the configuration created?

22. You are working on a network where the customer has a dedicated router with redundant Internet connections Tor outbound high-importance real-time audio streams from their datacenter

All of this traffic.

* originates from a single subnet

* uses a unique range of UDP ports

* is required to be routed to the dedicated router

All other traffic should route normally The SVI for the subnet containing the servers originating the traffic is located on the core routing switch in the datacenter.

What should be configured?

23. What is used to retrieve data stored in a Management Information Base (MIS)?

24. Your Director of Security asks you to assign AOS-CX switch management roles to new employees based on their specific job requirements. After the configuration was complete, it was noted that a user assigned with the administrators role did not have the appropriate level of access on the switch.

The user was not limited to viewing nonsensitive configuration information and a level of 1 was not assigned to their role.

Which default management role should have been assigned for the user?

25. A customer is looking Tor a wireless authentication solution for all of their loT devices that meet the following requirements

- The wireless traffic between the IoT devices and the Access Points must be encrypted

- Unique passphrase per device

- Use fingerprint information to perform role-based access

Which solutions will address the customer's requirements? (Select two.)

26. You need to drop excessive broadcast traffic on an ingress port or an ArubaOS-CX switch.

What is the best feature to use for this task?

27. Review the exhibit.





You are troubleshooting an issue with a 10 102.39 0/24 subnet which is also VLAN 1000 used Tor wireless clients on a pair of Aruba CX 8360 switches The subnet SVI is configured on the 8360 pair, and the DHCP server is a Microsoft Windows Server 2022 Standard with an IP address of 10 200 1.100. The 10.102.250.0/24 subnet is used for switch management.

A large number of DHCP requests are failing You are observing sporadic DHCP behavior across clients

attached to the CX 6100 switch.

Which action may help fix the issue?

A)





B)





C)





D)

28. A client is connecting to 802.1X SSID that has been configured in tunnel mode with the default AP-group settings.

After receiving Access-Accept from the RADIUS server, the Aruba Gateway will send Access-Accept to the AP through which tunnel?

29. Y ou need to have different routing-table requirements With Aruba CX 6300 VSF configuration.

Assuming the correct layer-2 VLAN already exists, how would you create a new SVI for a separate routing table?

30. In an ArubaOS 10 architecture using an AP and a gateway, what happens when a client attempts to join the network and the WLAN is configured with OWE?

31. You are troubleshooting an issue with a pair of Aruba CX 8360 switches configured with VSX Each switch has multiple VRFs. You need to find the IP address of a particular client device with a known MAC address You run the "show arp" command on the primary switch in the pair but do not find a matching entry for the client MAC address.

The client device is connected to an Aruba CX 6100 switch by VSX LAG.

Which action can be used to find the IP address successfully?

A)





B)





C)





D)

32. You are doing tests in your lab and with the following equipment specifications

* AP1 has a radio that generates a 10 dBm signal

* AP2 has a radio that generates a 11 dBm signal

* AP1 has an antenna with a gain of 9 dBi

* AP2 has an antenna with a gain of 12 dBi.

* The antenna cable for AP1 has a 2 dB loss

* The antenna cable for AP2 has a 3 dB loss

What would be the calculated Equivalent Isotropic Radiated Power (EIRP) for APT?

33. You are configuring an SVI on an Aruba CX switch that needs to have the following characteristics:

* VLANID = 25

. IPv4 address 10 105 43 1 with mask 255 255 255.0

* IPv6 address fd00:5708::f02d:4df6 with a 64 bit prefix length

* member of VRF eng

* VRF eng and VLAN 25 have not yet been created

Which command lists will satisfy the requirements with the least number of commands?

A)





B)





C)





D)

34. A customer is using stacked Aruba CX 6200 and CX 6300 switches for access and a VSX pair of Aruba CX 8325 as a collapsed core 802.1X is implemented for authentication. Due to the lack of cabling, some unmanaged switches are still in use Sometimes devices behind these switches cause network outages The switch should send a warning to the helpdesk when the problem occurs You have been asked to implement an effective solution to the problem.

What is the solution for this?

35. You are building a configuration in Central that will be used for a standardized network design for small sites for your company, you want to use GUI configuration for gateways and Aps, while template configuration for switches. You need to align with Aruba best practices .

Which set of actions will satisfy these requirements?

36. your customer has asked you to assign a switch management role for a new user The customer requires the user role to View switch configuration information and have access to the PUT and POST meth0ds for REST API.

Which default AOS-CX user role meets these requirements?

37. The customer needs a network hardware refresh to replace an aging Aruba 5406R core switch pair using spanning tree configuration with Aruba CX 8360-32YC switches.

What is the benefit of VSX clustering with the new solution?