Test Online NSE7_SDW-7.2 Dumps Questions to Be Certified

Category:

Comments:

0 Comments

Post Date:

December 3, 2024

To help prepare for the NSE7_SDW-7.2 exam, you may want to consider using NSE7_SDW-7.2 exam dumps questions. These questions are designed to test your knowledge and understanding of the topics covered on the exam. The more you practice answering NSE7_SDW-7.2 dumps questions, the more comfortable you will become with the exam format and the types of questions you can expect to see. NSE7_SDW-7.2 dumps can help reduce anxiety on exam day and improve your chances of success. Go and test free NSE7_SDW-7.2 exam dumps questions here.

Page 1 of 4

1. Which two performance SLA protocols enable you to verify that the server response contains a specific value? (Choose two.)

http

icmp

twamp

dns

2. Which statement best describes Zero-touch deployment in FortiGate SD-WAN?

Devices must be manually configured at each location.

Devices automatically configure themselves with a predefined configuration from FortiManager.

No user authentication is required for deployment.

Deployment can only be done remotely with no physical access to the device.

3. Which CLI command do you use to perform real-time troubleshooting for ADVPN negotiation?

get router info routing-table all

diagnose debug application ike

diagnose vpn tunnel list

get ipsec tunnel list

4. Which of the following is NOT a feature of Fortinet's SD-WAN?

Application control

Web filtering

Automatic cloud backups

VPN overlay support

5. What is the purpose of using multiple SD-WAN members in a single SD-WAN interface?

To provide a backup in case the primary interface fails

To increase the bandwidth by combining interfaces

To segregate traffic based on the type of application

To enforce different security policies

6. Which features ensure the security of SD-WAN? (Choose three)

Deep packet inspection

Application control

Next-generation firewall

Quality of Service

Intrusion Prevention System

7. Refer to the exhibits.

Exhibit A

Exhibit B

Exhibit A shows an SD-WAN event log and exhibit B shows the member status and the SD-WAN rule configuration.

Based on the exhibits, which two statements are correct? (Choose two.)

FortiGate updated the outgoing interface list on the rule so it prefers port2.

Port2 has the highest member priority.

Port2 has a lower latency than port1.

SD-WAN rule ID 1 is set to lowest cost (SLA) mode.

8. Which two statements are true about using SD-WAN to steer local-out traffic? (Choose two.)

FortiGate does not consider the source address of the packet when matching an SD-WAN rule for local-out traffic.

By default, local-out traffic does not use SD-WA

By default, FortiGate does not check if the selected member has a valid route to the destination.

You must configure each local-out feature individually, to use SD-WA

9. In FortiGate SD-WAN, which feature ensures the confidentiality and integrity of data?

IPSec VPN

SSL inspection

Antivirus

Web filtering

10. Which diagnostic command can you use to show the configured SD-WAN zones and their assigned members?

diagnose sys sdwan zone

diagnose sys sdwan service

diagnose sys sdwan member

diagnose sys sdwan interface

Page 2 of 4

11. Refer to the exhibits.

Exhibit A shows the packet duplication rule configuration, the SD-WAN zone status output, and the sniffer output on FortiGate acting as the sender. Exhibit B shows the sniffer output on a FortiGate acting as the receiver.

The administrator configured packet duplication on both FortiGate devices. The sniffer output on the sender FortiGate shows that FortiGate forwards an ICMP echo request packet over three overlays, but it only receives one reply packet through T_INET_1_0.

Based on the output shown in the exhibits, which two reasons can cause the observed behavior? (Choose two.)

On the receiver FortiGate, packet-de-duplication is enabled.

The ICMP echo request packets sent over T_INET_0_0 and T_MPLS_0 were dropped along the way.

The ICMP echo request packets received over T_INET_0_0 and T_MPLS_0 were offloaded to NP

On the sender FortiGate, duplication-max-num is set to 3.

12. The administrator uses the FortiManager SD-WAN overlay template to prepare an SD-WAN deployment. With information provided through the SD-WAN overlay template wizard, FortiManager creates templates ready to install on spoke and hub devices.

Select three templates created by the SD-WAN overlay template for a spoke device. (Choose three.)

System template

BGP template

IPsec tunnel template

CLI template

Overlay template

13. How can SD-WAN reduce operational costs?

By utilizing only MPLS links

By eliminating the need for internet connectivity

By automating traffic steering and network management

By requiring additional physical hardware

14. Which of the following criteria can be used for dynamic path selection in SD-WAN?

Time of day

User group

Source IP address

Destination port number

15. What are two common use cases for remote internet access (RIA)? (Choose two.)

Provide direct internet access on spokes

Provide internet access through the hub

Centralize security inspection on the hub

Provide thorough inspection on spokes

16. What are two reasons why FortiGate would be unable to complete the zero-touch provisioning process? (Choose two.)

The FortiGate cloud key has not been added to the FortiGate cloud portal.

FortiDeploy has connected with FortiGate and provided the initial configuration to contact FortiManager

The zero-touch provisioning process has completed internally, behind FortiGate.

FortiGate has obtained a configuration from the platform template in FortiGate cloud.

A factory reset performed on FortiGate.

17. Refer to the exhibit.

The exhibit shows output of the command diagnose 3vg sdwan service collected on a FortiGate device.

The administrator wants to know through which interface FortiGate will steer the traffic from local users on subnet 10.0. 1. 0/255.255.255.192 and with a destination of the business application Salesforce located on HO servers 10.0.0. 1.

Based on the exhibits, which two statements are correct? (Choose two.)

When FortiGate cannot recognize the application of the flow it steers the traffic destined to server 10.0.0.1 according to service rule 3.

FortiGate steers traffic to HO servers according to service rule 1 and it uses port1 or port2 because both interfaces are selected.

There is no service defined for the Salesforce application, so FortiGate will use the service rule 3 and steer the traffic through interface T_HQ 1.

FortiGate steers traffic for business application according to service rule 2 and steers traffic through port2.

18. Refer to the exhibit, which shows the IPsec phase 1 configuration of a spoke.

What must you configure on the IPsec phase 1 configuration for ADVPN to work with SD-WAN?

You must set ike-version to 1.

You must enable net-device.

You must enable auto-discovery-sender.

You must disable idle-timeout.

19. Refer to the exhibit.

The device exchanges routes using IBGP.

Which two statements are correct about the IBGP configuration and routing information on the device? (Choose two.)

Each BGP route is three hops away from the destination.

ibgp-multipath is disabled.

additional-path is enabled.

You can run the get router info routing-table database command to display the additional paths.

20. Which action fortigate performs on the traffic that is subject to a per-IP traffic shaper of 10 Mbps?

FortiGate applies traffic shaping to the original traffic direction only.

FortiGate shares 10 Mbps of bandwidth equally among all source IP addresses. RIAS

Fortigate limits each source ip address to a maximum bandwidth of 10 Mbps.

FortiGate guarantees a minimum of 10 Mbps of bandwidth to each source IP address.

Page 3 of 4

21. Refer to the exhibit.

In a dual-hub hub-and-spoke SD-WAN deployment, which is a benefit of disabling the anti-replay setting on the hubs?

It instructs the hub to disable the reordering of TCP packets on behalf of the receiver, to improve performance.

It instructs the hub to disable TCP sequence number check, which is required for TCP sessions originated from spokes to fail over back and forth between the hubs.

It instructs the hub to not check the ESP sequence numbers on IPsec traffic, to improve performance.

It instructs the hub to skip content inspection on TCP traffic, to improve performance.

22. Which type statements about the SD-WAN members are true? (Choose two.)

You can manually define the SD-WAN members sequence number.

Interfaces of type virtual wire pair can be used as SD-WAN members.

Interfaces of type VLAN can be used as SD-WAN members.

An SD-WAN member can belong to two or more SD-WAN zones.

23. Which SD-WAN setting enables FortiGate to delay the recovery of ADVPN shortcuts?

hold-down-time

link-down-failover

auto-discovery-shortcuts

idle-timeout

24. Which diagnostic command can you use to show the member utilization statistics measured by performance SLAs for the last 10 minutes?

diagnose sys sdwan sla-log

diagnose ays sdwan health-check

diagnose sys sdwan intf-sla-log

diagnose sys sdwan log

25. Refer to the exhibit.

Which are two expected behaviors of the traffic that matches the traffic shaper? (Choose two.)

The number of simultaneous connections among all source IP addresses cannot exceed five connections.

The traffic shaper limits the combined bandwidth of all connections to a maximum of 5 MB/sec.

The number of simultaneous connections allowed for each source IP address cannot exceed five connections.

The traffic shaper limits the bandwidth of each source IP address to a maximum of 625 KB/sec.

26. Exhibit.

Which conclusion about the packet debug flow output is correct?

The total number of daily sessions for 10.1.10.1 exceeded the maximum number of concurrent sessions configured in the traffic shaper, and the packet was dropped.

The packet size exceeded the outgoing interface MT

The number of concurrent sessions for 10.1.10.1 exceeded the maximum number of concurrent sessions configured in the traffic shaper, and the packet was dropped.

The number of concurrent sessions for 10.1.10.1 exceeded the maximum number of concurrent sessions configured in the firewall policy, and the packet was dropped.

27. Refer to the exhibit.

Based on the output shown in the exhibit, which two criteria on the SD-WAN member configuration can be used to select an outgoing interface in an SD-WAN rule? (Choose two.)

Set priority 10.

Set cost 15.

Set load-balance-mode source-ip-ip-based.

Set source 100.64.1.1.

28. What are the benefits of implementing SD-WAN? (Choose three)

Cost savings on WAN transport

Improved application performance

Enhanced security across the network

Reduced need for skilled IT personnel

Automatic provisioning of new sites

29. In FortiGate, what is the purpose of the SD-WAN rules?

To define security policies

To prioritize traffic based on source and destination

To direct traffic based on application

To log traffic for monitoring purposes

30. Refer to the exhibit.

Which statement explains the output shown in the exhibit?

FortiGate performed standard FIB routing on the session.

FortiGate will not re-evaluate the session following a firewall policy change.

FortiGate used 192.2.0.1 as the gateway for the original direction of the traffic.

FortiGate must re-evaluate the session due to routing change.

Page 4 of 4

31. Refer to the exhibit.

FortiGate has multiple dial-up VPN interfaces incoming on port1 that match only FIRST_VPN.

Which two configuration changes must be made to both IPsec VPN interfaces to allow incoming connections to match all possible IPsec dial-up interfaces? (Choose two.)

Specify a unique peer ID for each dial-up VPN interface.

Use different proposals are used between the interfaces.

Configure the IKE mode to be aggressive mode.

Use unique Diffie Hellman groups on each VPN interface.

32. 1.Refer to the exhibits.

Exhibit A shows two IPsec templates to define Branch_IPsec_1 and Branch_IPsec_2. Each template defines a VPN tunnel.

Exhibit B shows the error message that FortiManager displayed when the administrator tried to assign the second template to the FortiGate device.

Which statement best explain the cause for this issue?

You can assign only one template with a tunnel of fype static to each FortiGate device

You can define only one IPsec tunnel from branch devices to HUB1.

You can assign only one IPsec template to each FortiGate device.

You should review the branch1_fgt configuration for the already configured tunnel with the name HUB1-VPN2.

33. Which two components are essential for configuring a Secure SD-WAN solution? (Choose two)

FortiGate

FortiSandbox

FortiManager

FortiAnalyzer

34. In FortiGate SD-WAN, what does a Performance SLA help to determine?

The best path for application traffic

The encryption algorithm for secure traffic

The bandwidth limit for each application

The firewall policy to apply for traffic

35. Which three metrics are considered by SD-WAN when determining the best path for application traffic? (Choose three)

Jitter

Color

Latency

Bandwidth

Packet loss

36. Which three matching traffic criteria are available in SD-WAN rules? (Choose three.)

Type of physical link connection

Internet service database (ISDB) address object

Source and destination IP address

URL categories

Application signatures

37. Which two statements about SD-WAN central management are true? (Choose two.)

It does not allow you to monitor the status of SD-WAN members.

It is enabled or disabled on a per-ADOM basis.

It is enabled by default.

It uses templates to configure SD-WAN on managed devices.

TAGS:

NSE7_SDW-7.2, NSE7_SDW-7.2 exam dumps

Notify of

Label

Name*

Email*

Website

Label

Name*

Email*

Website

0 Comments

Oldest

Newest Most Voted

Inline Feedbacks

View all comments

Get NSE7_SDW-7.2 Dumps Full Version

Q&As: 122
Versions: PDF and Software Download Now

About Dumpsinfo

Dumpsinfo is a good platform providing the latest exam information and dumps questions for all IT certification exams. You can study all the latest exam dumps questions online.

[email protected]

Mon - Sat 9:00am - 6:00pm

Test Online NSE7_SDW-7.2 Dumps Questions to Be Certified

Related

Posts

FCP_ZCS_AD-7.4 Dumps Help You Study Objectives

Improve Your Knowledge with FCSS_NST_SE-7.4 Exam Dumps

Online FCP_FAZ_AD-7.4 Dumps Help You Understand Questions Well

FCP_FAZ_AN-7.4 Dumps Questions Increase Your Chance of Success

About Us

EMAIL

Services

Opening Hours