Pass NS0-093 Exam to Get Netapp Certification

1. A node has failed.

Which two conditions must be met for an automatic takeover to be triggered? (Choose two.)

2. Where is a kernel core file stored on a FAS9000 system that is running ONTAP 9.12.1 software?

A. on the partner root aggregate

B. on the root aggregate

C. on the mailbox disk

D. on the boot device

3. Which two commands from the Service Processor can provide information about installed field replaceable units (FRUs)? (Choose two.)

4. Which command can you use to confirm successful completion of an ONTAP upgrade?

A. system controller sp upgrade show

B. cluster image show-update-progress

C. job show Cjobtype upgrade

D. system node upgrade-revert upgrade-task Cnode Cversion

5. Which two statements regarding drive 1.2.3.L1 are true? (Choose two.)

6. Which LOADER prompt command ensures that POST is done on boot?

7. 1.In which two sections of AutoSupport can you find information to analyze the following panic? (Choose two.)

Panic_Message: PCI Error NMI from device(s):ErrSrcID(CorrSrc(0xf00),UCorrSrc(0x18)), RPT(0,3,0):Qlogic FC 16G adapter in slot 1 on Controller

8. Which RAID type provides protection against three disk failures?

9. Which two of the following methods are valid ways to access a node which is not booting? (Choose two.)

10. What happens when the command diskcopy is run from nodeshell?

11. Which two factors can increase the chances of experiencing a NetApp WAFL inconsistency on an aggregate? (Choose two.)

A. ignoring NetApp Active IQ health risks

B. constantly running at high load

C. using outdated disk firmware

D. upgrading frequently

12. Which three commands can be used to manually generate a kernel core file? (Choose three.)

13. A node has unexpectedly failed and is unresponsive through its node management interface.

Which two commands from the Service Processor are helpful to determine the root cause? (Choose two.)

14. What are two valid commands that can be used to trigger an AutoSupport? (Choose two.)

15. What is the default amount of time that a volume is available for recovery from the volume recovery queue following a volume deletion?

16. During which two operations is the NVRAM replayed by the high-availability (HA) partner? (Choose two.)

17. Which two statements are true about an IOM 12 module? (Choose two.)

18. Which two tools can you use to invoke AutoSupport? (Choose two.)

19. A node has panicked with a PCI/NMI error. Giveback has not been performed.

Which two commands should you run to collect the logs to determine the cause? (Choose two.)

20. You have upgraded your cluster from ONTAP 9.5 software to ONTAP 9.7 software. After two days, you notice that the upgrade is causing issues. You decide to revert to ONTAP 9.5 software.

Which two actions do you need to complete before you revert? (Choose two.)

A. Revert from ONTAP 9.7 software to ONTAP 9.6 software and then to ONTAP 9.5 software.

B. Delete all Snapshot copies from the past two days.

C. Reinstall your boot media and install ONTAP 9.5 software.

D. Wipe your config and restore from backup.

21. On an AFF A700 system, a SAS stack is connected to SAS ports 2a and 2b. The system has an additional 4-port SAS card in slot 9.

How should the cabling the corrected for best practices?

22. In the latest MANAGEMENT LOG AutoSupport message, you try to inspect the ENVIRONMENT section but find it empty.

In which section of AutoSupport can you find the reason?

23. In maintenance mode, which of the following commands shows disk ownership?

A. sysconfig Cv

B. disk show Cv

C. aggr status

D. storage show disk Cp