Prepare D-SNC-DY-00 Exam with Using D-SNC-DY-00 Dump Questions

If you are serious about passing your DELL EMC D-SNC-DY-00 certification exam, practicing with D-SNC-DY-00 dumps questions is an essential step in your preparation process. These D-SNC-DY-00 dumps will help you assess your knowledge, identify your strengths and weaknesses, and improve your chances of passing the exam on the first try. So why wait? Start practicing today and give yourself the best possible chance of success! Test free D-SNC-DY-00 exam dumps questions below.

Page 1 of 2

1. How many port channels can be assigned to a single port?

8

2

4

1

 Loading...

2. What is an iBGP neighbor relationship?

Two BGP neighbors have the same autonomous system numbers

Two BGP neighbors share L2VPN EVPN advertisements.

Two BGP neighbors share only native BGP networks.

Two BGP neighbors share only private networks.

 Loading...

3. Refer to the exhibit.





The route distinguisher was autogenerated.

Which VLAN is mapped to VNI410?

VLAN 410

VLAN41

VLAN 10

VLAN 26

 Loading...

4. Which two elements must be included in the show mclag interface x x command?

Peer-link port channel number

MC-LAG domain id

MC-LAG port channel number

MC-LAG VLAN id

 Loading...

5. What two methods can be used to upgrade or downgrade Enterprise SONiC?

Boot Loader

SONiC-CLI

MF-CLI

GRUB

 Loading...

6. What is the correct order of steps for data flow in asymmetric IRB frame encapsulation?

 Loading...

7. Which two elements are configured when RoCE is enabled?

IB

ETS

PFC

TCP

 Loading...

8. What does the show vian command display?

All configured VLANs

Only VLANs in an active state

All 4094 VLANs

 Loading...

9. What interface must be selected when configuring the management port from within the MF-CLI environment?

mgmt 1/1/1

ma 0/1

Management 0

eth0

 Loading...

10. What are the supported modes for the QSFP28 ports on an S5248F?

1x100G, 1x40 G, 2x50 G, and 4x25 G

1x100G, 1x40 G, 4x25 G, and 4x10 G

1x200G, 1x100 G, 1x40 G, and 4x25 G

1x400G, 2x200 G, 4x25

and 4x10 G

 Loading...

Page 2 of 2

11. VLAN 40 is configured in Switch A with an anycast-address of 192.168.40.254/24. The ARP neighbor suppression is enabled. Use the simulator to create a VTEP named vtep1 and assign an IP address of 10.10.10.1. Map the VNI 400 to VLAN 40.





see the explanation for all step by step solution with all explanation.

 Loading...

12. Refer to the exhibit.





Which three actions can a customer take to change interface Eth1/10 to operate in access mode for VLAN 40?

Configure the access mode for the switch port.

Delete VLAN 40.

Shut down the relevant interface.

Remove the current access VLAN configuration.

Enter it into the relevant interface.

 Loading...

13. Create port channel 10 on interfaces Eth 1/11 and 1/12, so that it connects to an already configured switch. A server will be connected on Eth 1/1. Both the server and port channel need VLAN 1 untagged and only VLAN 10 tagged.

Complete the configuration on Switch A.









see the explanation for all step by step solution with all explanation.

 Loading...

 Loading...