Use HPE2-W09 Dumps to Obtain HP Certification

Category:

HP Free Dumps

Comments:

0 Comments

Post Date:

April 19, 2023

If you're serious about obtaining the HPE Product Certified - Aruba Data Center Network Specialist certification, practicing with HP HPE2-W09 dumps questions is a must. By doing so, you'll become familiar with the exam format, identify knowledge gaps, develop time management skills, boost your confidence, and increase your chances of success. So, start practicing HPE2-W09 exam dumps today and give yourself the best chance of passing the HPE2-W09 exam! Test free Aruba Data Center Network Specialist Exam HPE2-W09 exam dumps below.

Page 1 of 4

1. You want to use NetEdit to configure an AtubaOS-CX switch.

Is this a minimum requirement for setting up communications between the switch and NetEdit?

Solution: Make sure that the SSH server is enabled.

Yes

2. Is this correct positioning of AtubaOS-CX switches in the data center?

Solution: A data center will use a leaf-spine topology and requires 64 leaf switches.

Aruba CX 8325 switches can be a good choice for both the leaf and spine switches.

Yes

3. Does this correctly describe how the Virtual Switching Extension (VSX) fabric reacts to various component failure scenarios?

Solution: The keepalive goes down, ISL link remains up. Switch-1 and Switch-2 remains up. The Split-recovery mode is disabled. In this case the secondary switch shutdowns Svls.

Yes

4. Can you attach this type of ArubaOS-CX interface to a VRF?

Solution: A Layer 3 VLAN interface

Yes

5. Is this something that NetEdit 2.0 does after it discovers a switch?

Solution: It enables SNMP on the switch, if disabled.

Yes

6. Refer to the exhibit.

You are adding a VLAN 30, subnet 10.0.30.0/24 to the network shown in the exhibit. (This network is simplified to just the relevant switches for this item.) This subnet belongs in VRF A, and you have added a Layer 3 VLAN 30 interface attached to this VRF on Switch-1. You want to make the services in this VLAN available to devices in 10.1.20.0/24 in VRF B.

Is this part of a valid setup for meeting these requirements?

Solution: Add VRF B as the secondary VRF on VLAN interface 30.

Yes

7. Is this something that NetEdit 2.0 does after it discovers a switch?

Solution: It collects Information about the switch hardware.

Yes

8. Refer to the exhibits.

Is this how the switch handles the traffic?

Solution: A frame with destination MAC address, 00:50:56:15:16:28, arrives with a VLAN 10 tag on 1/1/1 on Switch-1. Switch-1 encapsulates the frame with VXLAN and an IP header destined to 192.168.1.2.

Yes

9. AtubaOS-CX switches are acting as Virtual Extensible LAN (VXLAN) Tunnel Endpoints (VTEPs) WITHOUT Ethernet VPN (EVPN).

Does this correctly describe how the VTEPs handle VXLAN traffic forwarding?

Solution: VTEPs that use headend replication forward broadcasts as unicast packets to each VTEP in the same VNI.

Yes

10. Switch-1 and Switch-2 are AruDaOS-CX switches, which are part of a Virtual Switching Extension (VSX) fabric. Switch-2 is the primary member. Switch-2 experiences a power failure while Switch-1 remains up. Switch-2's power recovers, and Switch-2 reboots.

Is this one of the things that happens when Switch-2 finishes booting?

Solution: Switch-1 downloads its MAC forwarding table from Switch-2.

Yes

Page 2 of 4

11. Your task is to configure an EVPN solution for a dual-stack IPv4 and IPv6 protocol in the overlay networks. Is this statement about EVPN and IPv6 correct?

Solution: The IPv6 and IPv4 overlay networks can be encapsulated with VXLAN and transmitted through the underlay network.

Yes

12. You are using NetEdit to manage AruDaOS-CX switches. You want to deploy a standard config to the switches, but need the config to include a few device-specific settings such as hostname and IP address.

Is this what you should do?

Solution: omit the device-specific settings from the configuration plan and include them in command scripts instead.

Yes

13. Is this a use case for disabling split-recovery mode on ArubaOS-CX switches in a Virtual Switching Extension (VSX) fabric?

Solution: You want to prevent any possibility of a split brain situation from occurring if the keepalive link fails some time after the ISL.

Yes

14. Refer to the exhibit.

Switch-1, Switch-2, and the router run OSPF on LAG 100, which is a Layer 3 LAG. Does this correctly explain how to control how core-to-access traffic Is forwarded?

Solution: To force the router to use both links, ensure that active gateway is enabled on LAG 100 on both Switch-1 and Switch-2.

Yes

15. You are using NetEdit to manage AruDaOS-CX switches. You want to deploy a standard config to the switches, but need the config to include a few device-specific settings such as hostname and IP address.

Is this what you should do?

Solution: Inside a configuration plan, right-click any device-specific parameters and modify the parameter per-device.

Yes

16. Refer to the exhibits.

Is this how the switch-1 handles the traffic?

Solution: A broadcast arrives in VLAN 10 on Switch-1. Switch 1 forwards the frame on all interfaces assigned to VLAN 10, except the incoming interface. It encapsulates the broadcast with VXIAN and sends it to 192.168.1.3, out not 192.168.1.2.

Yes

17. Does this correctly describe how the Virtual Switching Extension (VSX) fabric reacts to various component failure scenarios?

Solution: The ISL goes down, and after a few seconds, the keepalive link goes down too.

Switch-1 and Switch-2 remains up.

The Split-recovery mode is enabled. In this case the secondary switch first shutdowns and then enables SVis.

Yes

18. Refer to the exhibit.

You need to set up an ArubaOS-CX switch to implement Virtual Extensible LAN (VXLAN)

WITHOUT Ethernet VPN (EVPN). The exhibit Indicates which servers should be part of the same VXLANs and the desired VNls for the VXLANs. Assume that the network is already configured to permit each ArubaOS-CX switch to reach each other switch's loopback interface.

Is this part of the process for setting up VXLAN to meet the requirements?

Solution: On Switch-1, set 192.168.1.3 as a peer IP address in the VNI 5020 context.

Yes

19. Is this a guideline for establishing a Virtual Switching Extension (VSX) Inter-Switch Link

(ISL) between two ArubaOS-CX switches?

Solution: Use the same speed on every link In the ISL.

Yes

20. Is this a use case for disabling split-recovery mode on ArubaOS-CX switches in a Virtual Switching Extension (VSX) fabric?

Solution: In situations in which the primary switch fails and then reboots, you want to make the primary switch take over again as the primary switch.

Yes

Page 3 of 4

21. Is this a guideline for establishing a Virtual Switching Extension (VSX) Inter-Switch Link (ISL) between two ArubaOS-CX switches?

Solution: Reserve the ISL for control plane traffic only.

Yes

22. AtubaOS-CX switches are acting as Virtual Extensible LAN (VXLAN) Tunnel Endpoints (VTEPs) WITHOUT Ethernet VPN (EVPN).

Does this correctly describe how the VTEPs handle VXLAN traffic forwarding?

Solution: VTEPs that use headend replication forward unicasts with unknown destination MAC addresses as unicast packets to each VTEP in the same VNl.

Yes

23. You ate using NetEdit to manage AruDaOS-CX switches. You want to deploy a standard conflg to the switches, but need the config to include a few device-specific settings such as hostname and IP address.

Is this what you should do?

Solution: Instead of using a standard configuration plan to deploy the configuration, create an auto config plan that uses scripts.

Yes

24. Your task is to configure an EVPN solution for a dual-stack IPv4 and IPv6 protocol in the overlay networks. Is this statement about EVPN and IPv6 correct?

Solution: Different virtual MAC must be used for IPv4 and IPv6 Active Gateway.

Yes

25. Is this correct positioning of AtubaOS-CX switches in the data center?

Solution: Aruba CX 8325 switches are an appropriate choice for leaf switches in a leaf-spine topology that uses Virtual Extensible LAN (VXLAN) with Ethernet VPN (EVPN).

Yes

26. 1.Switch-1 and Switch-2 are AruDaOS-CX switches, which are part of a Virtual Switching Extension (VSX) fabric. Switch-2 is the primary member. Switch-2 experiences a power failure while Switch-1 remains up. Switch-2's power recovers, and Switch-2 reboots.

Is this one of the things that happens when Switch-2 finishes booting? Solution: Switch-2 wails a period called the link-up delay before it enables Switched Virtual Interfaces (SVls) on its VSX LAGs.

Yes

27. You are using NetEdit to manage AruDaOS-CX switches. You want to deploy a standard config to the switches, but need the config to include a few device-specific settings such as hostname and IP address.

Is this what you should do?

Solution: Create two configuration plans, one with the standard config and one with the device-specific settings.

Yes

28. Your task is to configure an EVPN solution for a dual-stack IPv4 and IPv6 protocol in the overlay networks. Is this statement about EVPN and IPv6 correct?

Solution: IPv6 protocol can be encapsulated in the underlay network's IPv4 packets.

Yes

29. Refer to the exhibit.

Switch-1, Switch-2, and the router run OSPF on LAG 100, which is a Layer 3 LAG. Does this correctly explain how to control how core-to-access traffic Is forwarded?

Solution: To reduce the amount of traffic sent over the ISL between Switch-1 and Switch-2.

enable Equal Cost Multi Path (ECMP) on both Switch-1 and Switch-2.

Yes

30. Is this a use case for disabling split-recovery mode on ArubaOS-CX switches in a Virtual Switching Extension (VSX) fabric? Solution: You want an admin to manually fail traffic over to the secondary member if the primary member fails.

Yes

Page 4 of 4

31. Is this a way that a data center technology can help meet requirements for multi-tenancy?

Solution: Virtual Routing and Forwarding (VRF) enables multiple isolated Layer 3 domains, each with its own routing table, to share a physical network.

Yes

32. Is this a difference between a typical data center network's requirements and a typical campus network's requirements? Solution: Data center network traffic flows are typically east-west whereas while campus networks experience more north-south traffic.

Yes

33. Refer to the exhibit.

You want to enable devices in VRF B and VRF C to reach shared resources in VRF A. is this a valid strategy for meeting this goal?

Solution: Create a separate OSPF process for each VRF on Switch-1. Then redistribute each process into the other VRFs' processes.

Yes

34. Does this correctly describe the ArubaOS-CX architecture?

Solution: The ArubaOS-CX time-series database helps to support network analytics and troubleshooting.

Yes

35. Does this correctly describe routing information advertised by a VXLAN Tunnel Endpoint (VTEP) that uses EVPN?

Solution: MAC/IP advertisement routes advertise the MAC addresses that can be reached through the VTEP.

Yes

36. Is this statement about ARP and ND Suppression true?

Solution: ARP-Suppression and ND-Suppression must be enabled together.

Yes

37. You are configuring Ethernet Ring Protection Switching (ERPS) on an ArubaOS-CX switch.

Is this a guideline for configuring timers?

Solution: The hold off timer causes ERPS switches to delay unblocking a failed link after the link is restored. This can be useful to prevent frequent topology changes.

Yes

38. Refer to the exhibit.

You want to enable devices in VRF B and VRF C to reach shared resources in VRF A. is this a valid strategy for meeting this goal?

Solution: Place ad three VRF$ in the same OSPF process on Switch-1.

Yes

39. Your customer is using Nutanix AHV and they need a network orchestration tool to simplify network provisioning.

Is this operation supported when Aruba Fabric Composer (AFC) is integrated with Nutanix?

Solution: Automated provisioning of LAGs Between AHV and VSX

Yes

TAGS:

HPE2-W09, HPE2-W09 exam dumps

Notify of

Label

Name*

Email*

Website

Label

Name*

Email*

Website

0 Comments

Oldest

Newest Most Voted

Inline Feedbacks

View all comments

Get HPE2-W09 Dumps Full Version

Q&As: 129
Versions: PDF and Software Download Now

About Dumpsinfo

Dumpsinfo is a good platform providing the latest exam information and dumps questions for all IT certification exams. You can study all the latest exam dumps questions online.

[email protected]

Mon - Sat 9:00am - 6:00pm

Use HPE2-W09 Dumps to Obtain HP Certification

Related

Posts

Valid HPE0-G03 Exam Dumps are Your best Choice to Pass

HPE0-S59 Online Dumps Boost Your Career

Study Online HPE0-J68 Exam Dumps to Pass

Improve Your Knowledge with HPE2-B01 Exam Dumps

About Us

EMAIL

Services

Opening Hours